Improved Signal-to-noise Wideband Acoustic/ultrasonic Contact Displacement Sensors for Wood and Polymers

Authors

  • M. A. Hamstad

Keywords:

Wideband sensor, high-sensitivity sensor, displacement sensor, sensor design for wood

Abstract

Research leading to a significant improvement in the signal-to-noise sensitivity of wideband acoustic/ultrasonic contact displacement sensors for wood and polymers is described. Design principles for such high-sensitivity sensors are reviewed. Comparisons of response between ceramic and polymer piezoelectric elements are made on low modulus specimens, A new, practical high-sensitivity sensor is characterized and its signal-to-noise sensitivity is compared to that of an existing commercial wide band displacement sensor. The comparisons were made for polymer, maple, and redwood samples. Optimization of the piezoelectric element in the new sensor is considered. The typical increased sensitivity of the new sensor is about 30 dB over the existing commercial sensor.

References

Boltz, E. S., and C. M. Fortunko. 1995. Absolute sensitivity limits of various ultrasonic transducers. IEEE Ultrasonics Symposium, Seattle. WA. Pp. 951-954.nEitzen, D., and F. R. Breckenridge. 1987. Acoustic emission sensors and their calibration. Pages 122-134 in Paul Mcintire, ed. Nondestructive testing handbook, 2nd. ed., vol. 5. Am. Soc. for Nondestructive Testing.nFortunko, C. M., M. A. Hamstad, and D. W. Fitting. 1992. High-fidelity acoustic-emission sensor/preamplifier systems: Modeling and experiments. IEEE Ultrasonics Symposium, Phoenix, AZ. Pp. 327-333.nHamstad, M. A. 1994. An examination of piezoelectric polymers as wideband acoustic emission displacement sensors. Pages 79-86 in T. Kishi, Y. Mori, and M. Enoki, eds. Progress in Acoustic Emission VIII. The Japanese Society for NDI. Sapporo, Japan.nHamstad, M. A. 1995. On use of piezoelectric polymers as wideband acoustic emission displacement sensors for composites. Pages 115-119 in Proc. Fifth International Symposium on Acoustic Emission from Composite Material. ASNT, Columbus, OH.nHamstad, M. A., and C. M. Fortunko. 1995. Development of practical wideband high-fidelity acoustic emission sensors. Pages 281-288 in Vol. 2456 Proc. Nondestructive Evaluation of Aging Infrastructure 1995. SPIE—The International Society for Optical Engineering, Bellingham. WA.nIkeda, T. 1990. Fundamentals of piezoelectricity. Oxford University Press, Oxford, UK. 263 pp.nMorgan Matroc. 1991. Guide to modern piezoelectric ceramics. Bedford, OH. 10 pp.nPhysical Acoustics Corporation. 1995. Model 9208. Serial number AD84. Princeton, NJ.nProctor, T. M., Jr. 1982. An improved piezoelectric acoustic emission transducer. J. Acoust. Soc. Am. 71: 1163-1168.nScruby, C. B. 1984. Acoustic emission measurements using point-contact transducers. AERE Rep. R-11328. AERE Harwell, Oxfordshire, UK.nShiwa, M., H. Inaba, S. H. Carpenter. and T. Kishi. 1993. Development of high sensitivity and low-noise integrated acoustic emission sensor. Mater. Eval. 50(7): 868-874.nTyree, M. T., and J. S. Sperry. 1989. Characterization and propagation of acoustic emission signals in woody plants: Towards an improved acoustic emission counter. Plant Cell Environ. 12:371-382.n

Downloads

Published

2007-06-19

Issue

Number 3 / July 1997

Section

Research Contributions

License

The copyright of an article published in Wood and Fiber Science is transferred to the Society of Wood Science and Technology (for U. S. Government employees: to the extent transferable), effective if and when the article is accepted for publication. This transfer grants the Society of Wood Science and Technology permission to republish all or any part of the article in any form, e.g., reprints for sale, microfiche, proceedings, etc. However, the authors reserve the following as set forth in the Copyright Law:

1. All proprietary rights other than copyright, such as patent rights.

2. The right to grant or refuse permission to third parties to republish all or part of the article or translations thereof. In the case of whole articles, such third parties must obtain Society of Wood Science and Technology written permission as well. However, the Society may grant rights with respect to Journal issues as a whole.

3. The right to use all or part of this article in future works of their own, such as lectures, press releases, reviews, text books, or reprint books.