Quantification of uf and pf Resins in MDF Fiber with an X-Ray Fluorescence Spectrometer

Authors

  • Yongqun Xie
  • Martin Feng
  • James Deng

Keywords:

X-ray fluorescence spectrometer, urea-formaldehyde resin, phenol-formaldehyde resin, copper sulfate, sodium, medium density fiberboard, distribution, uniformity, resin content, resin distribution and fiber

Abstract

This article describes methods to quantify urea-formaldehyde (UF) resin and phenol-formaldehyde (PF) resin contents in medium density fiberboard (MDF) using a wavelength dispersive X-ray fluorescence spectrometer (WDXRF). The methods are based on the principle that a specific metallic element shows its characteristic X-ray fluorescence spectrum, the intensity of which is correlated quantitatively to its concentration. In the case of UF-blended MDF fiber, 2.4% copper sulfate pentahydrate CuSO4.5H2O (based on resin solids) was premixed with the resin as a labeling agent. Quantification of copper ion was performed using XRF. Based on calibrations with laboratory-prepared standard fiber samples of known UF resin and copper quantities, the results of XRF measurements were converted to resin loading rates. In the case of PF-blended fiber, the PF resin contents in the MDF fiber samples were successfully quantified by measuring the existing sodium ion Na+ in the resol resin with XRF. Linear calibration curves between fluorescence intensity of copper or sodium and resin content were established respectively for UF and PF resins. Test results show that the methods were precise and reliable.

References

American Wood-Preservers' Association (AWPA). Standard A9-96, Standard Method for Analysis of Treated Wood and Treating Solutions by X-ray Spectroscopy.nBersadskii, A. L. 1956. Forces acting on cutting tools during woodworking. Forestry Abstracts 1956.nBertin, E. P. 1971. Principles and practice of X-ray spectrometric analysis. Plenum Press, New York-London.nChow, S. 1974. Morphologic accessibility of wood adhesives. J. Appl. Polym. Sci.18:2785-2796.nClark, G. L. 1955. Applied X-rays. McGraw-Hill Book Company, INC. New York, NY.nFeng, M. W. 2001. Detection and measurement of UF resin distribution in MDF. Proc. 5th European Panel Products Symposium, The BioComposites Centre, Llandudno, Wales.nU.S. Government. 1946. Office of Production Research & Development. 1946. Final report on laminated wood products. Forestry-Abstracts 1946-47.nPreston, R. D. 1939. The wall of the conifer tracheas as a single spiral complex. Forestry Abstracts 1939-40.nPreston, R. D. 1947. The fine structure of the fibers of normal and tension wood in beech as revealed by X-rays. Forestry21(1).nPreston, R. D., and A. Allsopp. 1939. An X-ray examination of delignified and cellulosan-free cellulose and its significance for the problem of the structure of cell walls. Biodynamika53:8.nRISI. North American Wood Panels Forecast, January 2003. Pp. 200-202.nRyan, K. G. 1986. Preparation techniques for X-ray analysis in the transmission electron microscope of wood treated with copper-chrome-arsenate. Mater. Organ., 21:3, 223-234.nWalter, G. B. 1960. Physical methods in chemical analysis. Academic Press, New York and London.nWangaard, F. F. 1942. The effect of wood structure upon heat conductivity. Trans. Am. Soc. Mech. Eng.1942:8.n

Downloads

Published

2007-06-05

Issue

Number 3 / July 2004

Section

Research Contributions

License

The copyright of an article published in Wood and Fiber Science is transferred to the Society of Wood Science and Technology (for U. S. Government employees: to the extent transferable), effective if and when the article is accepted for publication. This transfer grants the Society of Wood Science and Technology permission to republish all or any part of the article in any form, e.g., reprints for sale, microfiche, proceedings, etc. However, the authors reserve the following as set forth in the Copyright Law:

1. All proprietary rights other than copyright, such as patent rights.

2. The right to grant or refuse permission to third parties to republish all or part of the article or translations thereof. In the case of whole articles, such third parties must obtain Society of Wood Science and Technology written permission as well. However, the Society may grant rights with respect to Journal issues as a whole.

3. The right to use all or part of this article in future works of their own, such as lectures, press releases, reviews, text books, or reprint books.