Open Access Open Access  Restricted Access Subscription or Fee Access

ACOUSTIC WAVE PROPAGATION IN STANDING TREES —PART II. EFFECTS OF TREE DIAMETER AND JUVENILE WOOD

Fenglu Liu, Houjiang Zhang, Xiping Wang, Fang Jiang, Wenhua Yu, Robert J Ross

Abstract


The objective of this study was to investigate the effects of tree diameter and juvenile wood on acoustic wave propagation in standing trees. Two-layer tree models with various diameters and proportions of juvenile wood were constructed to examine the effects of these two factors on propagation patterns and velocity of acoustic waves. The simulation results and analysis indicated that acoustic wave propagation in trees is dependent on both tree diameter and propagation distance. In the context of time-of-flight (TOF) acoustic measurement on standing trees with a test span of 1.2 m, when tree diameter is 10 cm or less, or slenderness is twelve or greater, wave propagates as quasi-plane waves in tree trunk, and the tree velocity determined using the TOF method is then comparable to the log velocity measured using the acoustic resonance method. When tree diameter is 40 cm or larger, or slenderness is three or less, wave propagates as dilatational waves in the tree trunk; thus, the three-dimensional wave equation should be considered for wood property prediction. When tree diameter falls between 10 and 40 cm or slenderness falls between 3 and 12, wave propagation is in a transitional phase. Mathematical models were developed to convert the tree velocity in the transition mode to the resonance velocity. It was found that juvenile wood content resulted in a 113-m/s reduction in acoustic velocity. In addition, our analysis indicated that wave propagation in standing trees is controlled by the wood properties of entire cross section, not just the outerwood. Therefore, the wave velocity measured on standing trees reflects the global properties of the wood between the two measuring points.


Keywords


Acoustic waves, COMSOL Multiphysics software, dilatational wave, plane wave, wave front, wave velocity, trees.

Full Text:

PDF

References


Andrews M (2003) Which acoustic speed? In: Proceedings, 13th International Symposium on Nondestructive Testing of Wood, University of California Berkeley, California, August 19-21, 2002. pp. 156-165.

Carter P, Briggs D, Ross RJ, Wang X (2005) Acoustic testing to enhance western forest values and meet customer wood quality needs. Productivity of western forests: A forest products focus. Gen Tech Rep PNW-GTR-642. USDA For Serv Pacific Northwest Research Station, Portland, OR. pp: 121-129

Chauhan SS, Walker JCF (2006) Variation in acoustic velocity and density with age, and their interrelationships in radiata pine. For Ecol Mgmt 229(1-3):388- 394.

Grabianowski M, Manley B, Walker JCF (2006) Acoustic measurements on standing trees, logs and green lumber. Wood Sci Technol 40(3):205-216.

Hsu CY (2003) Radiata pine wood anatomy structure and biophysical properties, Ph.D. thesis, School of Forestry, University of Canterbury, Christchurch, New Zealand, 147 pp.

Joe B, Dickson R, Raymond CA (2004) Prediction of Eucalyptus dunnii and Pinus radiata timber stiffness using acoustics. RIRDC Publ. 04/013. 121 p.

Lasserre JP, Mason EG, Watt MS (2004) The influence of initial stocking on corewood stiffness in a clonal experiment on 11-year-old Pinus radiata [D. Don]. New Z J For Sci 49:18–23.

Lindström H, Harris P, Nakada R (2002) Methods for measuring stiffness of young trees. Holz Roh- Werkst 60:165-174.

Liu F, Jiang F, Zhang J, Zhang H (2015) Twelve elastic constant values of larch forest. J Northwest For Univ 30(6):227-231.

Liu F, Wang X, Zhang H, Jiang F, Yu W, Liang S, Fu F, Ross RJ (2020) Acoustic wave propagation in standing trees – Part 1. Numerical simulation. Wood Fiber Sci 52(1): 53-72.

Legg M, Bradley S (2016) Measurement of stiffness of standing trees and felled logs using acoustics: a review. J Acoust Soc Am 139(2): 588-604.

Meyers MA (1994) Dynamic behavior of materials. Wiley, New York, NY.

Mora CR, Schimleck LR, Isik F, Mahon JM, Clark A, Daniels RF (2009) Relationship between acoustic variables and different measures of stiffness in standing Pinus taeda trees. Can J For Res 39(8):1421-1429.

Wang X (2013) Acoustic measurements on trees and logs: a review and analysis. Wood Sci Technol 47(5):965-97.

Wang X, Carter P, Ross RJ, Brashaw BK (2007a) Acoustic assessment of wood quality of raw forest materials–A path to increased profitability. Forest Prod J 57(5): 6-14.

Wang X, Ross RJ, Brashaw BK, Punches J, Erickson JR, Forsman JW, Pellerin R (2004) Diameter effect on stress-wave evaluation of modulus of elasticity of logs. Wood and Fiber Sci. 36(3):368-377.

Wang X, Ross RJ, Carter P (2007b) Acoustic evaluation of wood quality in standing trees. Part I. Acoustic wave behavior. Wood Fiber Sci 39(1):28-38.


Refbacks

  • There are currently no refbacks.