Open Access Open Access  Restricted Access Subscription or Fee Access

Effect of wood density and cracks on the moisture content of coated Norway spruce (Picea abies (L.) Karst)

T. Sjökvist, J. Niklewski, Å. Blom

Abstract


A protective coating is often used on the cladding of wooden facades to limit the absorption of moisture. Low wood moisture content (MC) is essential to obtain satisfactory durability performance. Wood density is known to influence the water sorption and crack formation of uncoated wood. However, the effect of density on the aforementioned behaviors of coated spruce is not yet fully understood. Six-years of data on the crack formation and the MC variation of outdoor exposed panels are analyzed in this article. The outdoor test was complemented by a subsequent laboratory experiment, wherein the MC variation was monitored at different depths on the board during artificial water spraying. The aim of this research was to increase the knowledge about how wood density and aging affect the water sorption of coated spruce through the crack formation. The results indicated that wood density had an impact on the overall sorption behavior of coated spruce. Low-density spruce contributed to faster water absorption and desorption processes than coated samples with higher density. However, the observed correlation to density was limited to a condition with an intact coating. High-density characteristics contributed to more crack formation, and the density–sorption relationship reversed with a cracked coating. A cracked coating caused a strong local increase in the MC of the wood at the location of the cracks. Weather-exposed replicates without cracks had a higher MC in the core of the board compared with the value beneath the coating. The higher MC is probably due to the water sorption of the uncoated backside of the panel. Such an occurrence raised awareness for future studies to account for multidimensional sorption behavior from all sides of the panel. The local difference in MC also raises awareness for future studies to investigate local MC variations (as opposed to the global average of the panel) in research on the durability of coated wood.


Keywords


Alkyd, Acrylic

Full Text:

PDF

References


Ahola P, Derbyshire H, Hora G, De Meijer M (1999) Water protection of wooden window joinery painted with low organic solvent content paints with known composition. Part 1. Results of inter-laboratory tests. Eur J Wood Wood Prod 57(1):45-50.

Boutelje J (1973) On the relationship between structure and the shrinkage and swelling of the wood in Swedish pine (Pinus sylvestris) and spruce (Picea abies). Sv Papperstidn 1973(2):78-83.

Brischke C, Rapp AO, Bayerbach R (2008) Measurement system for long-term recording of wood moisture content with internal conductively glued electrodes. Build Environ 43(10):1566-1574.

Eaton RA, Hale MDC (1993) Wood: Decay, pests, and protection. Chapman & Hall, London, UK. 546 pp.

Ekstedt J (2002) Influence of coating additives on water vapour absorption and desorption in Norway spruce. Holzforschung 56(6):663-668.

Ekstedt J (2003) Influence of coating system composition on moisture dynamic performance of coated wood. J Coating Technol 75(938):27-37.

Esping B (1992) Tratorkning. 1a, Grunder i torkning. Tratek, Stockholm, Sweden. 234 pp.

Fredriksson M, Wadso L, Johansson P (2013) Small resistive wood moisture sensors: A method for moisture content determination in wood structures. Eur J Wood Wood Prod 71(4):515-524.

Fredriksson M, Wadso L, Johansson P, Ulvcrona T (2016) Microclimate and moisture content profile measurements in rain exposed Norway spruce (Picea abies (L.) Karst.) joints. Wood Mater Sci Eng 11(4):189-200.

Grull G, Truskaller M, Podgorski L, Bollmus S, De Windt I, Suttie E (2013) Moisture conditions in coated wood panels during 24 months natural weathering at five sites in Europe. Wood Mater Sci Eng 8(2):95-110.

Hjort S (1996) Full-scale method for testing moisture conditions in painted wood paneling. J Coating Technol 68(856):31-39.

Kalnins MA, Feist WC (1993) Increase in wettability of wood with weathering. Forest Prod J 43(2):55-57.

Kishino M, Nakano T (2004) Artificial weathering of tropical woods. Part 1: Changes in wettability. Holzforschung 58(5):552-557.

Kollmann FFP, Cote WA (1968) Principles of wood science and technology. Springer-Verlag, Berlin, Germany. 592 pp.

Nejad M, Cooper P (2011) Exterior wood coatings. Part-2: Modeling correlation between coating properties and their weathering performance. J Coating Technol Res 8(4):459-467.

Niklewski J, Isaksson T, Fruhwald Hansson E, Thelandersson S (2018a) Moisture conditions of rain exposed glue-laminated timber members: The effect of different detailing. Wood Mater Sci Eng 13(3):129-140.

Niklewski J, Brischke C, Fruhwald Hansson E, Meyer-Veltrup L (2018b) Moisture behavior of weathered wood surfaces during cyclic wetting: Measurements and modeling. Wood Sci Technol 52(6):1431-1450.

Norberg P (1999) Monitoring wood moisture content using the WETCORR method part 1: Background and theoretical considerations. Eur J Wood Wood Prod 57(6):448-453.

Otten KA, Brischke C, Meyer C (2017) Material moisture content of wood and cement mortars—Electrical resistance based measurements in the high ohmic range. Constr Build Mater 153:640-646.

Petty JA (1970) Permeability and structure of the wood of Sitka spruce. Proc Roy Soc Lond Ser B Biol Sci 175(1039):149-166.

Siau JF (1984) Transport processes in wood. Springer- Verlag, Berlin, Germany; New York, NY. 248 pp.

Sivertsen MS, Vestøl GI (2010) Liquid water absorption in uncoated Norway spruce (Picea abies) claddings as affected by origin and wood properties. Wood Mater Sci Eng 5(3):181-193.

Sjokvist T, Blom A° (2016) Influence of some wood characteristics on the variation of moisture content in outdoor exposed coated Norway spruce panels. 70th FPS International Convention. Forest Products Society, Portland, OR.

Skaar C (1988) Wood-water relations. Springer-Verlag, New York, NY. 283 pp.

Stamm AJ (1929) The fiber-saturation point of wood as obtained from electrical conductivity measurements. Ind Eng Chem 1(2):94-97.

Telkki VV, Yliniemi M, Jokisaari J (2013) Moisture in softwoods: Fiber saturation point, hydroxyl site content, and the amount of micropores as determined from NMR relaxation time distributions. Holzforschung 67(3):291-300.

Thygesen LG, Tang Engelund E, Hoffmeyer P (2010) Water sorption in wood and modified wood at high values of relative humidity. Part I: Results for untreated, acetylated, and furfurylated Norway spruce. Holzforschung 64(3):315-323.

Tiemann HD (1906) Effect of moisture upon the strength and stiffness of wood. U.S. Department of Agriculture, Forest Service, Washington, WA. 144 pp.

Van Meel PA, Erich SJF, Huinink HP, Kopinga K, De Jong J, Adan OCG (2011) Moisture transport in coated wood. Prog Org Coat 72(4):686-694.

Williams RS, Jourdain C, Daisey GI, Springate RW (2000) Wood properties affecting finish service life. J Coating Technol 72(902):35-42.

Zelinka SL (2010) Moisture relations and physical properties of wood. In RJ Ross, ed. Wood handbook: Wood as an engineering material. 190: U.S. Department of Agriculture, Forest Service, Madison, WI.

Zelinka SL, Wiedenhoeft AC, Glass SV, Ruffinatto F (2015) Anatomically informed mesoscale electrical impedance spectroscopy in southern pine and the electric field distribution for pin-type electric moisture metres. Wood Mater Sci Eng 10(2):189-196.


Refbacks

  • There are currently no refbacks.