Organosolv Pulping of Poplar Wood From Short-Rotation Intensive Culture Plantations

Authors

  • Reyes Sierra-Alvarez
  • Bôke F. Tjeerdsma

Keywords:

Populus, short-rotation intensive culture poplar hybrids, juvenile wood, organosolv pulp, yield, kappa, degree of polymerization, handsheet properties

Abstract

This study investigates the suitability of the ethanol organosolv process to pulp poplar wood from short-rotation intensive culture (SRIC) plantations. Wood chips were prepared from 9-year-old SRIC debarked poplar logs (Populus deltoides x trichocarpa 'Donk'), and they were subjected to ethanol/ water organosolv pulping in lab-scale batch reactors. The effect of the main process variables (i.e., time, temperature, ethanol concentration) on the pulp yield and quality was examined. Upon process optimization, the papermaking properties of the pulp obtained were determined.

The most selective conditions in terms of delignification and pulp viscosity were found at an ethanol concentration of 60% (v/v) in water, a pulping time of 210 min and, a temperature of 195 C. Under these conditions, good delignification was achieved (kappa no. 20.2), with pulp yields of 54.3%, and degree of polymerization (DP) values ranging from 1,900 to 2,000. The strength properties of hand-sheets made from the SRIC poplar organosolv pulp were in the same range, except for a lower tear factor, as those reported for hardwood (semi-) chemical pulps. The results obtained indicate the promising potentials of the organosolv process for the chemical pulping of fast-grown poplar wood cultivated in short rotations.

References

Aziz, S., and K. Sarkanen. 1989. Organosolv pulping— A review. Tappi 72(3): 169-175.nBrowning, B. L. 1967. Methods of wood chemistry, vol. 2. Intersci. Publ., New York. Pp. 717-746.nCronlund, M., and J. Powers. 1992. Bleaching of ALCELL® organosolv pulps using conventional and nonchlorine bleaching sequences. Tappi 75(6):189-193.nDix, B., and E. Roffael. 1989. Halbzelstoffe nach dem NSSC-Verfahren aus Pappelholz. Holz Roh- Werkst. 47:437-445.nDix, B., E. Roffael, G. Becker, and K. Gruβ. 1992. Eigen- schaften von Zellstoffen aus Holz von Pappeln unter-schiedlicher Klone, Standorte und Baumalter. Das Papier 46(10):583-592.nEdel, E. 1989. Das Organocell-Verfahren. Bericht uber den Betrieb einer Demonstrationsanlage. Das Papier 43(10A):V116-V123.nGoyal, G. C., and J. H. Lora. 1991. Kinetics of delignification and lignin characteristics in autocatalyzed organosolv pulping of hardwoods. Proc. Int. Symp. Wood Pulp. Chem., Melbourne, Australia, vol 1. Pp. 205-212.nGoyal, G. C., and J. H. Lora. 1991. Kinetics of delignification and lignin characteristics in autocatalyzed organosolv pulping of hardwoods. Proc. Int. Symp. Wood Pulp. Chem., and E. K. Pye. 1992. Autocatalyzed organosolv pulping of hardwoods: Effect of pulping conditions on pulp properties and characteristics of soluble and residual lignin. Tappi. 2:110-116.nHunt, K., and J. L. Keays. 1973. Short-rotation trembling aspen trees (Populus tremuloides Michx.) for kraft pulp. Can. J. Forest Res. 3:180-184.nLabosky, P., T. W. Bowersox, and P. R. Blankenhorn. 1983. Kraft pulp yields and paper properties obtained from first and second rotations of three hybrid poplar clones. Wood Fiber Sci. 15(1):81-89.nLai, Y.-Z., and X.-P. Guo. 1992. Acid-catalyzed hydrolysis of aryl ether linkages in wood. 1. Estimation of non-cyclic α-aryl ether units. Holzforschung 46(4):311-314.nLora, J. H., and S. Aziz. 1985. Organosolv pulping: A versatile approach to wood refining. Tappi. 68(8):94-97.nMarton, R., G. R. Stairs, and E. J. Screiner. 1968. Influence of growth rate and clonal effect on wood anatomy and pulping properties of hybrid poplars. Tappi. 51(5):230-235.nMcDonough, T. J. 1993. The chemistry of organosolv delignification. Tappi. 76(8): 186-193.nNimz, H. H., C. Granzow, and A. Berg. 1986. Ace-tosolv pulping. Holz Roh- Werkst. 44:362.nPaszner, L., and H. J. Cho. 1989. Organosolv pulping: Acid catalysis options and their effect on fiber quality and delignification. Tappi. 2:136-142.nPhelps, J. E., J. G. Isebrands, D. W. Einspahr, J. B. Crist, and J. A. Sturos. 1985. Wood and paper properties of vacuum airlift segregated juvenile poplar wholetree chips. Wood Fiber Sci. 17(4):528-539.nPye, E. K., and J. H. Lora. 1991. The Alcell™ Process: A proven alternative to kraft pulping. Tappi. 3:113-118.nRoffael, E., and B. Dix. 1994. Einfluβ der Eigenschaften des Holzes einiger Pappelklone auf seine Verwertung. Forstarchiv 65:43-53.nSnook, S. K., P. Labosky, T. W. Bowersox, and P. R. Blankenhorn. 1986. Pulp and papermaking properties of a hybrid poplar clone grown under four management strategies and two soil sites. Wood Fiber Sci. 18(1): 157-167.nTirtowidjojo, S., K. V. Sarkanen, F. Pla, and J. L. Mccarthy. 1988. Kinetics of organosolv delignification in batch- and flow-through reactors. Holzforschung 42(3): 177-183.nTjeerdsma, B. F., and F. H. A. Zomers. 1993. Organosolv pulping of hemp, vol. 1. Proc. Int. Symp. Wood Pulp. Chem. Beijing, China. Pp. 514-522.nTjeerdsma, B. F., F. H. A. Zomers, E. C. Wilkinson, and R. Sierra-Alvarez. 1994. Modelling organosolv pulping of hemp. Holzforschung 48(5):415-422.nWinner, S. R., G. C. Goyal, E. K. Pye, and J. H. Lora. 1991. Pulping of agricultural residues by the Alcell process. Proc. Tappi 1991 Pulping Conf., Atlanta, GA.n

Downloads

Published

2007-06-19

Issue

Number 4 / October 1995

Section

Research Contributions

License

The copyright of an article published in Wood and Fiber Science is transferred to the Society of Wood Science and Technology (for U. S. Government employees: to the extent transferable), effective if and when the article is accepted for publication. This transfer grants the Society of Wood Science and Technology permission to republish all or any part of the article in any form, e.g., reprints for sale, microfiche, proceedings, etc. However, the authors reserve the following as set forth in the Copyright Law:

1. All proprietary rights other than copyright, such as patent rights.

2. The right to grant or refuse permission to third parties to republish all or part of the article or translations thereof. In the case of whole articles, such third parties must obtain Society of Wood Science and Technology written permission as well. However, the Society may grant rights with respect to Journal issues as a whole.

3. The right to use all or part of this article in future works of their own, such as lectures, press releases, reviews, text books, or reprint books.