The Simultaneous Drying and Densification of Sapwood

Authors

  • John G. Haygreen
  • David H. Daniels

Abstract

A process for densifying wood while simultaneously drying it in a platen press is described. The effect of various pressure-time functions on the density distribution of the final product is discussed as is the effect of these functions on the dimensional stability characteristics of the product. Low density wood of high permeability, generally sapwood, is applicable to this process. A product with the most uniform density distribution and the best stability characteristics is obtained by rapidly compressing the material after the center has reached 212 F. Springback of such material after soaking for three weeks amounts to 10 to 15%. More stable material can be produced by steeping green wood in phenol formaldehyde impregnating resin prior to drying and densification. Springback after soaking can then be reduced to 1 to 2%. The bending strength properties of the densified material was found to be proportional to the density in a range from 0.60 to 1.00 gm per cm3. Some estimates of cost of the process are presented.

References

Stamm, A. J., and R. M. Seborg. 1944. Resin-treated, laminated, compressed wood. Forest Products Laboratory Report No. 1381.nSeborg, R. M., M. A. Millett, and A. J. Stamm. 1945. Heat stabilized compressed wood. Mech. Eng., 67(1): 25-31.nSeborg, R. M., Harold Tarkow, and A. J. Stamm. 1962. Modified woods. Forest Products Laboratory Report No. 2192.nStamm, A. J. 1964. Wood and cellulose science, p. 353-358. The Ronald Press, New York.nHaygreen, J. G., and Kalevi Turkia. 1968. Technical and economic considerations in the platen drying of aspen sapwood and paper birch cut-stock. Forest Prod. J., 18(8): 43-50.n

Downloads

Published

2007-06-22

Issue

Number 1 / Spring 1969

Section

Research Contributions

License

The copyright of an article published in Wood and Fiber Science is transferred to the Society of Wood Science and Technology (for U. S. Government employees: to the extent transferable), effective if and when the article is accepted for publication. This transfer grants the Society of Wood Science and Technology permission to republish all or any part of the article in any form, e.g., reprints for sale, microfiche, proceedings, etc. However, the authors reserve the following as set forth in the Copyright Law:

1. All proprietary rights other than copyright, such as patent rights.

2. The right to grant or refuse permission to third parties to republish all or part of the article or translations thereof. In the case of whole articles, such third parties must obtain Society of Wood Science and Technology written permission as well. However, the Society may grant rights with respect to Journal issues as a whole.

3. The right to use all or part of this article in future works of their own, such as lectures, press releases, reviews, text books, or reprint books.